Installation instructions for Aprilia RS 125 [all construction years] - gas train for 34mm dellorto carburetor - reinforced

• Step 1: Preparation
• Step 2: Tools and materials
• Step 3: Remove the old gas train
• Step 4: Install new gas train
• Step 5: Setting the carburetor
• Step 6: completion and test

Step 1: Preparation

Before you start installing the reinforced gas train, make sure that the machine is on a stable surface and the engine is switched off.

Step 2: Tools and materials

Make sure you have all the tools and materials required. This includes a 10mm wrench, a cross -slot screwdriver and the new reinforced gas train for the 34mm dellorto carburetor.

Step 3: Remove the old gas train

Start loosening the old gas train on the carburetor and the throttle. Remove the screws and carefully pull out the gas train.

Step 4: Install new gas train

Give the new reinforced gas train in the same place where the old man was. Make sure that the train sits well and attach it to both the carburetor and the throttle.

Step 5: Setting the carburetor

Check the setting of the carburetor to ensure that the new gas train works correctly. If necessary, adjust the idle speed and the throttle valve position.

Step 6: completion and test

After everything is installed and set, start the engine and test the gas train. Make sure that the throttle reaction is quick and smooth.

How often should I check the gas train?

It is recommended to check the gas train at least once a season, especially before longer trips.

What do I do when the gas pull tears?

If the gas pull tears, it should be replaced immediately. Do not drive with a damaged gas train because this can lead to dangerous situations.