Step 1: Preparation

Before starting with the assembly of the LED blinkers, make sure you have all the tools and materials required. This includes a screwdriver, pliers, insulating tape and the LED indicators with resistances.

Step 2: Assembly of the turn signals

Start with the assembly of the turn signals on your motorcycle. Screw the turn signals with the M8 thread to the intended brackets. Make sure that the indicators sit safely and do not wiggle.

Step 3: Connect the cables

Connect the cables of the turn signals to the electrical system of your motorcycle. Make sure you use the right cables to avoid short circuits. If necessary, use a cable connector and isolate the connections with insulating tape.

Step 4: Install resistance

Install the supplied resistors to adapt the flashing frequency. These should be installed near the indicators to ensure optimal function. Make sure that the resistors are securely attached and do not touch cables that could move.

Step 5: function test

After installation, check whether all indicators work properly. Turn on the turn signals and test the flashing frequency to ensure that it works correctly.

Step 6: Care and maintenance

To extend the lifespan of your LED indicators, regularly clean them from dirt and dust. Check the cable connections and resistances for damage and replace defective parts immediately.

How long do LED turn signals last?

LED blinkers usually have a long service life of up to 50,000 hours, depending on the quality and the conditions under which they are used.

Can I install the indicators myself?

Yes, the installation of the indicators is easy and can be carried out with basic tools. However, note the electrical safety precautions.

4 LED turn signal black resistances [e -test mark] - Universal M8 thread

Price: 49.00 €