Installation instructions for 4 LED turn signals black resistances [E -test mark] - KTM RC 125 390 790 890 1290 Duke

• Step 1: Preparation
• Step 2: Remove old indicators
• Step 3: Install resistors
• Step 4: attach new indicators
• Step 5: carry out the function test
• Step 6: Care instructions

Step 1: Preparation

Before you start installing the new LED blinkers, make sure that you have all the required tools and materials. This includes the new LED indicators, resistors, wrenches and possibly insulating tape.

Step 2: Remove old indicators

Switch off the motorcycle and remove the battery to avoid short circuits. Loosen the screws of the old indicators and pull the cables off.

Step 3: Install resistors

To correctly operate the LED indicators, you must install the resistors. Connect the resistors according to the enclosed instructions to the motorcycle wiring harness. Make sure to secure the connections well.

Step 4: attach new indicators

Attach the new LED indicators to the intended areas. Make sure that you are assembled safely and stably. Close the cables of the turn signals to the corresponding connection.

Step 5: carry out the function test

Before you put together the motorcycle, carry out a function test. Connect the battery and check whether the new indicators work properly.

Step 6: Care instructions

To increase the lifespan of your new indicators, clean them regularly with a soft cloth and avoid aggressive cleaning agents.

FAQ 1: Are the indicator e-test mark approved?

Yes, the LED blinkers are provided with an e-test mark and therefore approved for road traffic.

FAQ 2: Can I install the indicators myself?

Yes, the installation is easy and can be carried out in just a few steps. However, pay attention to the correct wiring and installation of the resistors.