4 LED turn signal black resistances [E -test mark] - Ducati Monster

Step 1: Preparation

Make sure you have all the tools and materials required. This includes the new LED indicators, resistances, a screwdriver, pliers and insulating tape.

Step 2: Remove the old indicators

Switch off the ignition and remove the old turn signals. Loosen the screws and pull the cables off. Make sure not to damage the cables.

Step 3: Installation of the LED indicators

Place the new LED blinkers in the place of the old indicators. Attach them with the screws and connect the cables according to the color markings.

Step 4: attach the resistance

To ensure correct flashing of the LED indicators, you must connect the resistances. Connect a resistor in series with every turn signal and insulate the connections well.

Step 5: Test the indicators

Turn on the ignition and test the turn signals. Make sure that you flash evenly. If not, check the connections again.

Step 6: Care of the indicators

To extend the lifespan of the indicators, clean them regularly with a soft cloth and avoid aggressive cleaning agents.

FAQ 1: Are the LED blinkers suitable for all Ducati Monster models?

The LED blinkers are specially designed for the models Ducati Monster 600, 620, 750, 900, 1000, S4 and S4R and therefore fit optimally.

FAQ 2: How can I adjust the flashing frequency?

The flashing frequency can be adapted by using resistors or by replacing the flinaries. Consult your Ducati's manual for further information.

4 LED blinker black resistances [E -test mark] - Ducati Monster 600 620 750 1000 S4 S4R

Price: 49.00 €

Make an offer
Make an offer
Make an offer