Installation instructions for 4 LED indicators Clear resistors [E -test mark] - BMW G 310 F 700 800 R S GS

• Step 1: Preparation
• Step 2: Remove indicators
• Step 3: Install resistors
• Step 4: Connect indicators
• Step 5: function test
• Step 6: completion and care

Step 1: Preparation

Make sure that you have all the required tools and materials, including the new LED indicators, resistances and any required cable connectors.

Step 2: Remove indicators

Switch off the ignition and remove the old turn signals. Loosen the screws that hold the indicators in their place and pull the cable plugs off.

Step 3: Install resistors

Connect the resistances to the cables of the new LED indicators. Make sure to connect the correct cables to avoid short circuits.

Step 4: Connect indicators

Connect the new LED indicators to the wiring of the motorcycle. Make sure the connections are fixed and no wires are exposed.

Step 5: function test

Turn on the ignition and test the new turn signals to ensure that you work properly. Check the flashing frequency and the brightness.

Step 6: completion and care

After everything works correctly, fasten the indicators safely and clean the area around the indicators. Check the function of the indicators regularly.

FAQ 1: Can I install the indicators myself?

Yes, the installation of the turn signals can usually be carried out itself as long as you have fundamental knowledge of dealing with tools and electronics.

FAQ 2: What do I do if the indicators don't work?

Check all the connections and make sure that the resistors are correctly connected. If the problem continues, consult a specialist.