Step 1: Preparation

Make sure that the Ducati Hypermotard is on a stable surface. Pull off the ignition and remove the key to avoid accidental starts. Provide all the necessary tools and the new turn signals.

Step 2: Remove old indicators

Screw the old indicators and separate the cables. Make sure not to damage the cables as you need them for the new turn signals. Hold the screws in a safe place so that you can reuse them later.

Step 3: attach new indicators

Attach the new LED indicators to the intended areas. Connect the cables according to the color detection (usually black for mass and colored for the signal). Make sure that the connections are safe.

Step 4: Install resistance

Install the supplied resistances near the turn signals. These are necessary to adapt the flashing frequency of the LEDs. Connect the resistances to the cables by establishing the corresponding connections.

Step 5: Check cabling

Check all the connections again to ensure that everything is connected correctly. Make sure that there are no cables loose and there are no short connections.

Step 6: final examination

Place the key in the ignition and test the new indicators. Check both the flashing and brightness of the LEDs. If everything works, you can attach the covers again and consider the work to be completed.

How long do LED turn signals last?

LED blinkers have a significantly longer lifespan than conventional incandescent lamps, often over 50,000 hours if they are installed and cared for properly.

Can I install the indicators myself?

Yes, the installation of the blinkers is relatively simple and can be carried out with basic tools and a little technical understanding.

4 LED blinker Clear resistance [E -test mark] - Ducati Hypermotard 796 821 939 950 1100

Price: 49.00 €