Installation instructions for 4 LED blinker black resistances [E -test mark] - Husqvarna Supermoto Vitpilen Svartpilen 401 701

• Step 1: required tools and materials
• Step 2: Preparation of the motorcycle
• Step 3: Remove the old indicators
• Step 4: Installation of the new LED blinkers
• Step 5: Connection of the resistances
• Step 6: Test and final steps

Step 1: required tools and materials

To install the 4 LED blinker, you need the following tools and materials:

Step 2: Preparation of the motorcycle

Make sure the motorcycle is on a stable surface. Switch off the ignition and remove the key to ensure that no electrical components are activated.

Step 3: Remove the old indicators

Start removing the old indicators. Loosen the screws that attach the indicators to the bracket and pull the plugs off the old indicators.

Step 4: Installation of the new LED blinkers

Place the new LED blinkers to the places provided and attach them to the screws. Make sure that the indicators are safely and stable.

Step 5: Connection of the resistances

Connect the resistances in parallel to the new turn signal connections. Make sure to use the right cables and to isolate all connections well to avoid short circuits.

Step 6: Test and final steps

After everything is installed, switch on the ignition and test the new indicators. Check if you flash correctly. Then close all the covers and make sure that everything is safe and neat.

Care tips

FAQ

How often should the indicators be checked?

It is advisable to check the indicators on every motorcycle exit to ensure that they work perfectly.

Can I install the indicators myself?

Yes, the installation can be carried out with the right tools and some technical understanding. Make sure you follow the instructions carefully.