Step 1: Preparation

Make sure you have all the tools and materials required. These include the new LED turn signals, resistors, a screwdriver, pliers and electrical insulating tape.

Step 2: Remove old indicators

Switch off the motorcycle and separate the battery. Remove the old turn signals by loosening the screws and removing the cables.

Step 3: attach resistance

Install the resistors in parallel to the new LED indicators to ensure the correct flashing frequency. Connect the cables and isolate the connections with an electrical insulating tape.

Step 4: Install new turn signals

Attach the new LED indicators to the intended areas. Make sure you connect the cables correctly and secure the turn signals with the screws.

Step 5: carry out the function test

Connect the battery again and test the new turn signals. Make sure that these flash correctly and that no error messages are displayed.

Step 6: Care instructions

To extend the lifespan of the turn signals, regularly clean them from dirt and dust. Check the cable connections for firm seat and rust.

FAQ 1: Are the LED indicators compatible with all models?

The LED blinkers are specially designed for the Kawasaki ER-5 and ER-6N. It is recommended to check the compatibility before buying.

FAQ 2: How can I adjust the flashing frequency?

The flashing frequency can be controlled by using suitable resistors. Make sure that the resistors have the right Ohm number for your turn signals.

2 LED turn signal black resistances [E-test mark]-Kawasaki Er-5 Er-6n

Price: € 29