Step 1: Preparation

Before you start installing the new LED blinker, make sure that your motorcycle ignition is switched off. Secure a clean and well -lit working area.

Step 2: Tools ready

For this installation you need a cross -slot screwdriver, a side cutter, pliers and possibly shrink tubes to insulate the connections.

Step 3: Remove old indicators

Start removing the old indicators. Loosen the screws of the turn signal bracket with the cross -slot screwdriver and carefully separate the electrical connections.

Step 4: Install new LED indicators

Take the new LED blinker and connect them to the electrical connections. Make sure to consider the polarity. Attach the turn signals to the bracket with the screws.

Step 5: Connect resistance

Connect the supplied resistances to the LED turn signals to ensure a correct flashing rate. Use the pliers to secure the wires safely and insulate the connections with shrink tubes.

Step 6: Test and lock

After all connections are made, switch on the ignition and test the new indicators. Make sure you work correctly and that the flashing frequency is optimal.

FAQ 1: How long do LED turn signals last?

LED blinkers have a longer lifespan than conventional light bulbs and can last up to 50,000 hours, depending on the use and conditions.

FAQ 2: Do I need special resistance for my BMW?

Yes, special resistors are required to correctly adjust the flashing frequency, since LED blinkers consume less electricity than conventional turn signals.

2 LED blinker Clear resistance [E -test mark] - BMW G 310 F 700 800 R S GS

Price: € 29