Installation instructions for 2 LED blinker Clear resistors [E -test mark] - Suzuki DR BIG 800S 650 750 800 600

• Step 1: Preparation
• Step 2: Laying tools
• Step 3: Remove old indicators
• Step 4: Install new turn signals
• Step 5: Connect resistance
• Step 6: Functional test

Step 1: Preparation

Before you start installing the LED flashing, make sure that your motorcycle is on a stable surface and the engine is switched off. Wear suitable protective equipment, including gloves and safety glasses.

Step 2: Laying tools

For the installation you need the following tools: a screwdriver (cross and slot), a side cutter, a soldering iron and soldering. Put everything ready to make the process easier.

Step 3: Remove old indicators

Start reducing the old indicators. Loosen the screws that attach the indicators to the bracket and carefully pull the cables off. Make sure not to damage cables.

Step 4: Install new turn signals

Place the new LED indicators in the place of the old indicators. Attach them with the screws you have previously removed. Make sure you sit tight and don't wobble.

Step 5: Connect resistance

To correctly operate the LED indicators, you must connect the supplied resistors. Solve the resistors to the cables of the turn signals and connect them to the power supply. Make sure to consider the polarity.

Step 6: Functional test

After everything is connected, switch on the ignition and test the turn signals. Make sure that you flash correctly. If the indicators do not work properly, check the connections and the resistances.

Care tips

FAQ

How long last LED indicators?

LED indicators have a significantly longer lifespan than conventional incandescent lamps, often up to 50,000 hours.

Can I install the indicators myself?

Yes, the installation of the turn signals is relatively simple and can be carried out with basic tools yourself as long as you carefully follow the instructions.