Step 1: Preparation

Before you start installation, make sure that the motorcycle is on a stable surface. Make sure the engine is switched off and remove the key. Provide all the required tools, such as wrenches, screwdrivers and possibly a pliers.

Step 2: Remove the old indicators

Start removing the old indicators. Loosen the screws that hold the turn signals in their place and carefully pull them off. Make sure not to damage the cables as you remove the indicators.

Step 3: Installation of the new indicators

Take the new LED blinker and use it in the place of the old turn signal. Make sure that the assembly position is identical. Attach the turn signals with the screwed screws and tighten them.

Step 4: Connecting the resistance

To ensure that the new LED blinkers work correctly, you must connect the supplied resistors. Connect the resistors in parallel to the turn signal cables. Make sure that the connections are safe.

Step 5: Test the indicators

Start the motorcycle and test the new turn signals to ensure that you work correctly. Check both the left and right side to ensure that all indicators shine and flash.

Step 6: final assembly

After the turn signals have been tested and work perfectly, bring all the covers and cladding back. Make sure that everything is properly attached and that no cables are visible.

Care tips

FAQ 1: Are the indicators compatible with every motorcycle?

The LED blinkers are specially designed for the Husqvarna TE WRE models 1250, 250, 350, 410, 450, 510 and 610. Use on other models can result in restrictions in functionality.

FAQ 2: Do I need special tools for installation?

To install the turn signals, you need basic tools such as a wrench and a screwdriver. A multimeter can be helpful to check the electrical connections.

2 LED turn signal black resistances [E -test mark] - Husqvarna te WRE 1250 250 350 450 510 610

Price: € 29