Installation instructions for 2 LED blinker black resistances [E -test mark] - Husqvarna Supermoto Vitpilen Svartpilen 401 701

• Step 1: Preparation
• Step 2: Remove old indicators
• Step 3: Connect resistance
• Step 4: mount new indicators
• Step 5: function test
• Step 6: Care and maintenance

Step 1: Preparation

Before you start installing the LED blinkers, make sure that you have all the required tools ready: screwdriver, pliers and, if necessary, a soldering iron. Also separate the battery of your Husqvarna to ensure that no electrical problems occur.

Step 2: Remove old indicators

Open the blinker cover and remove the screws that hold the old indicators. Carefully pull off the cables. Make sure not to damage the cables because you have to use them for the new turn signals.

Step 3: Connect resistance

Connect the resistances to the cables of the new LED indicators. Make sure to consider the polarity. If necessary, use shrink hoses or insulating tape to secure the connections and protect short circuits.

Step 4: mount new indicators

Place the new LED blinkers to the places intended and attach them to the screws. Make sure that you sit tight and don't wobble. Check the alignment of the turn signals to ensure that you are clearly visible.

Step 5: function test

Connect the battery again and test the new LED blinker. Make sure you flash correctly and the resistors work properly. If everything is fine, you can attach the covers again.

Step 6: Care and maintenance

Check the function of your LED indicators and the connections regularly. If necessary, clean the indicators with a damp cloth to remove dirt and dust. Make sure that the indicators are not blocked and always remain clearly visible.

FAQ 1: Are the LED blinkers suitable for all Husqvarna models?

The LED blinkers are specially designed for the Husqvarna Vitpilen and Svartpilen 401 and 701. Check the compatibility with your model before buying.

FAQ 2: Do I need special tools for installation?

Basic tools such as screwdrivers and pliers are sufficient to install the LED blinkers. In some cases, a soldering iron may be necessary to properly connect the resistors.