Installation instructions for 4 LED turn signals black resistances [E-test mark]-Suzuki GSX-S750 S950 S1000

• Step 1: Preparation
• Step 2: Remove old indicators
• Step 3: Install new turn signals
• Step 4: Connect resistance
• Step 5: Check the indicator
• Step 6: Care and maintenance

Step 1: Preparation

Before you start installing the new LED blinkers, make sure you have the right tools on hand. This includes a screwdriver, a pliers set and possibly cable ties. Switch off the ignition of the motorcycle and remove the key.

Step 2: Remove old indicators

Start removing the old indicators. Loosen the screws that attach the indicators to the bracket and carefully pull off the turn signals. Make sure not to damage the cables.

Step 3: Install new turn signals

Take the new LED indicators and put the cables into the corresponding connections. Attach the turn signals with the supplied screws to the bracket of the motorcycle.

Step 4: Connect resistance

The new LED blinkers need resistance to function correctly. Connect the resistances to the cables of the turn signals. Make sure you observe the polarity and isolate the connections well to avoid short circuits.

Step 5: Check the indicator

After everything is installed, switch on the ignition and test the turn signals. Make sure you flash properly and do not occur. Also check whether the resistors get warm, which is normal.

Step 6: Care and maintenance

Regular checking of the indicators is important. Clean the turn signals regularly from dirt and dust. Make sure that no cables are damaged and the connections are tight.

How do I recognize whether my indicators are defective?

If the indicators do not flash or display faster flashing, this can indicate a defect. Check the connections and turn signals themselves.

Can I also use the LED indicators on other motorcycles?

The LED blinkers are usually designed for certain models. Check the compatibility before installing it on another motorcycle.