Installation instructions for 4 LED turn signals black resistances [E -test mark] - Kawasaki KX KMX 125 250

• Step 1: Preparation
• Step 2: Remove the turn signal housing
• Step 3: Climb old turn signals
• Step 4: Connect new turn signals
• Step 5: Install resistance
• Step 6: Functional test

Step 1: Preparation

Make sure you have all the tools and materials required, including the new LED turn signals, resistances, screwdrivers and a cable cutter.

Step 2: Remove the turn signal housing

Remove the housing of the old indicator. Loosen the screws with a screwdriver and carefully remove the turn signals.

Step 3: Climb old turn signals

Clamp the old turn signals from the wiring. Make sure not to damage the cables because they will reuse them for the new indicators.

Step 4: Connect new turn signals

Connect the new LED indicators to the cables that were previously disconnected. Make sure to consider the correct pole (plus and minus).

Step 5: Install resistance

Install the supplied resistors in parallel with the new indicators. This is important to ensure the right blinking behavior.

Step 6: Functional test

Test the new turn signals by turning on the light. Check whether the indicators flash correctly and no malfunctions occur.

Care tips

FAQ: Are the LED indicators suitable for other models?

The LED blinkers are specially developed for Kawasaki KX KMX 125 and 250, but may also be adapted to other models.

FAQ: What do I do if the indicators don't work properly?

Check all the connections and make sure that the resistors are installed correctly. If the problem continues, there could be a defect in the indicators.