Installation instructions for 4 LED indicators Clear resistors [E-test mark]-Suzuki GSX-S750 S950 S1000

• Step 1: Preparation
• Step 2: Remove old indicators
• Step 3: Install resistors
• Step 4: mount new indicators
• Step 5: Functional test
• Step 6: Care instructions

Step 1: Preparation

Make sure you have all the required tools and materials ready: LED indicators, resistors, wrenches and insulating tape.

Step 2: Remove old indicators

Switch off the ignition and separate the battery. Remove the old turn signals by loosening the screws and removing the cables.

Step 3: Install resistors

Connect the resistances to the cables of the new LED indicators. Make sure to isolate the connections well to avoid short circuits.

Step 4: mount new indicators

Assemble the new turn signals at the intended area. Attach them with the screws and tighten them.

Step 5: Functional test

Connect the battery again and test the new turn signals. Make sure that you flash properly and have the right speed.

Step 6: Care instructions

To extend the lifespan of the indicators, clean them regularly from dirt and dust. Check the connection points for corrosion and use loose screws.

FAQ 1: Why do I need resistance for LED blinkers?

LED blinkers have less power consumption than conventional light bulbs. Without resistance, malfunctions can occur, such as flashing too quickly.

FAQ 2: Where do I install the resistances?

The resistors should be installed near the turn signals to easily keep the cable connections. Make sure to secure and insulate them safely.