Installation instructions for 2 LED turn signals black resistances [E-test mark]-Yamaha MT-03 MT-09 MT-125

• Step 1: Preparation
• Step 2: Remove old indicators
• Step 3: Install resistors
• Step 4: mount new indicators
• Step 5: Check wiring
• Step 6: Functional test

Step 1: Preparation

Make sure you have all the required tools and materials: wrenches, insulating tape and the new LED indicators with resistances.

Step 2: Remove old indicators

Switch off the ignition and remove the old turn signals. Loosen the screws and pull the cables off.

Step 3: Install resistors

Connect the resistances to the new LED indicators. Make sure to isolate the cables correctly to avoid short circuits.

Step 4: mount new indicators

Assemble the new LED indicators in the previous places. Fasten the screws to prevent wobbling.

Step 5: Check wiring

Check all the connections and make sure that the cables are properly connected. Use insulating tape to secure the wires.

Step 6: Functional test

Turn on the ignition and test the new turn signals. Make sure that you flash correctly and the resistors work properly.

FAQ 1: Do I need special tools for installation?

For the installation you need basic tools such as a wrench and possibly a soldering iron if you want to solder the cables.

FAQ 2: Are the resistance necessary?

Yes, the resistances are necessary to adapt the flashing frequency of the LED indicators and ensure that they work correctly.