Step 1: Preparation

Before you start installing the new LED blinkers, make sure you have the right tools on hand. Are required: a screwdriver, pliers and possibly a multimeter to check the electrical connections.

Step 2: Remove old indicators

Switch off the motorcycle and remove the motorcycle battery to avoid short circuits. Loosen the screws of the old indicators and pull the cables off. Write down the cable connections for the later installation of the new turn signals.

Step 3: attach new indicators

Place the new LED blinkers in the place of the old indicators. Make sure that the brackets sit safely and firmly. Connect the cables from step 2 in accordance with your note.

Step 4: Install resistance

Install the supplied resistances near the LED turn signals to ensure the correct flashing frequency. Correctly connect the resistors to the power supply and isolate the connections with insulating tape.

Step 5: function test

Connect the motorcycle battery again and test the turn signals. Check whether the turn signals work correctly and the flashing frequency is stable. If you have any problems, check the cable connections and the resistances.

Step 6: Care instructions

To extend the lifespan of your new LED blinkers, clean them regularly from dirt and dust. Make sure that all electrical connections are dry and protected from corrosion.

FAQ 1: Are the resistance really necessary?

Yes, the resistances are necessary to ensure a correct flashing frequency of the LED turn signals. Without them, the indicators can flash too quickly or at all.

FAQ 2: Can I install the indicators myself?

Yes, if you have basic mechanical skills and tools, you can install the indicators yourself. Simply follow the instructions carefully.

2 LED blinker Clear resistance [E -test mark] - Kawasaki Klr 650 250 600 Klx 200 Kla

Price: € 29