Step 1: Make preparations

Make sure you have all the tools and materials required. This includes the new LED indicators, resistors, a screwdriver and cable tie.

Step 2: disconnect power supply

Before you start installation, clamp the battery to avoid short circuits and electrical blows. First remove the minus pole.

Step 3: Remove old indicators

Screw the old indicators and pull the cables off. Make sure not to damage the cables because you will use them for the new indicators.

Step 4: Install new LED indicators

Place the new LED blinkers to the places intended and screw them tight. Make sure you are properly aligned.

Step 5: Connect resistance

Connect the resistors to the turn signal cables to ensure the correct flashing frequency. Follow the manufacturer's instructions for wiring.

Step 6: Review and test

Connect the battery again and test the flashing function. Check whether all indicators work correctly and do not display warning lights on the dashboard.

FAQ 1: Are the LED indicators compatible with every motorcycle?

The LED blinkers are specially designed for Husqvarna TE WRE 1250 250 350 450 510 610 models. Please check the compatibility with your model before buying.

FAQ 2: Is the installation difficult?

The installation is relatively simple and can be carried out with basic tools. However, if you are unsure, you consider consulting a specialist.

2 LED blinker Clear resistance [E -test mark] - Husqvarna TE WRE 1250 250 410 450 510 610

Price: € 29