Installation instructions for 2 LED indicators Clear resistors [E -test mark] - Honda Hornet 600 750 900

• Step 1: Preparation
• Step 2: Tools and Material
• Step 3: Expansion of the old indicators
• Step 4: Installation of the new LED blinkers
• Step 5: Connection of the resistances
• Step 6: Functional test

Step 1: Preparation

Make sure your motorcycle is on a stable surface and the engine is parked. Wear protective clothing and gloves.

Step 2: Tools and Material

You need a screwdriver, a pliers, insulating tape and the new LED blinkers with the corresponding resistors.

Step 3: Expansion of the old indicators

Start loosening the screws that attach the old turn signals to the bracket. Carefully separate the cable connections to avoid damage.

Step 4: Installation of the new LED blinkers

Place the new LED blinkers to the places intended and screw them tight. Make sure that the indicators sit safely.

Step 5: Connection of the resistances

Connect the resistors in parallel to the LED indicators to ensure a correct function. Isolate the connections with insulating tape to avoid short circuits.

Step 6: Functional test

Check the function of the new turn signals by starting the motorcycle and pressing the turn signals. Make sure that you flash properly both left and right.

Question 1: Do the resistance have to be installed?

Yes, the resistors are necessary to correctly blink the indicators and to prevent the warning indicator from being activated.

Question 2: What to do if the indicators don't work?

Check all the connections and make sure that the resistors are correctly connected. Test the turn signals again and replace defective parts if necessary.