KTM 390 Duke RC390 [Intact] - motorcycle battery

✔️ New part

€44,00 EUR

Available Now!

The Intact Bike Power battery GEL YTX9-BS Represent a top class among motorcycle batteries, which was specially developed for modern motorcycles with numerous electrical consumers and ABS. Their outstanding properties ensure optimal performance and reliability.

Technical data:

  • Width x depth x height: 151 x 87 x 107 mm
  • Cold start current: 170 a (DIN)
  • Battery type: maintenance -free, activated AGM
  • Volume: 1696 cm³
  • Weight: 3000 g
  • Length: 164 mm
  • Width: 94 mm
  • Height: 110 mm
  • CCA (A): 170
  • Volt: 12V
  • Acid pack: no

Performance characteristics

By using fleece separators and the defined electrolyte in gel form, this battery achieves up to 30 % more power compared to conventional motorcycle batteries. It also offers a very low self -discharge and high vibrating resistance, which makes it particularly durable.

Care and maintenance

In order to maximize the lifespan of your motorcycle battery, the following points should be observed:

  • The battery should only be used in accordance with its destination, mainly for starting and operating vehicles with an incinerated engine.
  • Keep the surface of the battery clean and dry. Avoid the deposition of oils or liquids to prevent crawl currents and thus an increased self -discharge.
  • Check the fill level of the battery regularly, at least every 6 months, and refill cleaned water if necessary (no accumulator acid).
  • If there is a sign of a high water loss, the function of the charge controller should be checked by the specialist.

Furthermore, it is important to check the charging status of the battery regularly, ideally you should ensure that the battery is always loaded at least 75 %. An optimal load of 100 % is ideal to use the full performance of your battery.

Note that a deep discharge is usually due to self -fault and often leads to the total failure of the battery. The ideal storage temperature during a long stand phases is between 10 and 15 degrees Celsius, around the self -discharge and the water Minimize loss.